Injectors problems

Injectors: Part that rationalizes the fuel intake into the cylinders.
Read more
Related problems:

Top problems

Injectors aren't firing

Ford Ranger 2012 3.2 35000 miles
Replaced valves on the cylinder head and now the engine doesn't fire when diagnosed it report's engine speed and camshaft position sensor
karabomonageng1130@gmail.com from Canada a year ago  
KA
2 reports 

Truck runs rough and stall out of the blue

Ford Ranger 1993 4.0 26800 miles
The motor runs rough and stalls out of the blue we have changed the fuel pump and injectors, plugs plug wires throttle position sensor checked the mass air flow and it is reading fine fuel pressure is good the check engine light will come on but it will not show a code had it put on computer and it shows every thing is working fine also changed the fuel pressure unit
cstrief from United States 8 years ago  
CS
18 reports 
Cqmanager from Canada 7 years ago
Try cleaning your injectors...alot of times they get fouled up and why it stalls... seafoam or equivalent has always worked for me
Comment

Glow plugs light not working, diesel pump not distributing diesel to i

Ford Ranger 2006 Wlt  253000 miles
Trying to start engine , but no diesel into injectors
Tla1243 from South Africa a year ago  
TL
2 replies 
Bruce from United States a year ago
If the glow plugs light is not working and the diesel pump is not distributing diesel to the injectors, it could be a problem with the fuel system or a malfunctioning component.
Here are a few things you can try:

Check the fuel pump. The fuel pump is responsible for delivering diesel fuel from the tank to the injectors. If the fuel pump is not functioning properly, it could cause the engine to not start or run poorly. You can test the fuel pump by listening for a humming noise when the key is turned to the "on" position.
Check the fuel pump relay. The fuel pump relay is responsible for providing power to the fuel pump. If the fuel pump relay is not functioning properly, it could cause the fuel pump to not receive power and the engine to not start or run poorly. You can test the fuel pump relay by checking for voltage at the fuel pump connector.
Check the fuel filter. A clogged fuel filter can restrict the flow of diesel fuel and cause the engine to not start or run poorly.
Check the fuel lines. If the fuel lines are damaged or leaking, it could cause the engine to not start or run poorly.
If you are unable to identify the source of the problem or if the issue persists after checking these components, I recommend having a mechanic diagnose and repair the issue to ensure that the problem is properly addressed and the vehicle is safe to drive.
Nicoleen from South Africa 7 months ago
Why is there pressure on injector 4. The fuel line pipe keeps falling out at injector 4 causing the diesel to run out badly.
Comment

Injector failure

Ford Ranger 2013 supercab 300000 miles
Hi. My 3. 2 Ford Ranger t6 simultaneously kills injectors. I have changed, the tank pressure pump, the injector pump and common rail as well as the injectors. It will fail on cylinder 1 injector, if I replace it, it will fail cylinder 3 or 5 injector.

If the truck is parked and i rave the truck hard, above 2000rpms, nothing happens, but once I drive it and try to do a hard acceleration, the injectors will start to simultaneously fail again

I replaced all injectors with new ones feeling that maybe the repaired ones had an issue, the same thing eventually happened.

I now feel it is an electrical problem or error code message from the computer box... I need help

What could be the problem
Denford from other 2 years ago  
DE
13 reports 
tezza from Australia a year ago
Did you end up solving the issue?
The Ace from South Africa a year ago
I have the same issue T6 2.2, replaced injectors with new ones flushed out the fuel system, dropped the tank. I just tried another set of injectors now number 3 fires a couple of times then gets stuck open i end up with diesel in my oil. Any resolve?
Bossie from South Africa 7 months ago
Check the inlet sensor. On my Pajero I unplugged it and the problem was solved. The engine light came on and I will clear this once I receive the new MAF sensor. It is on order.
Comment

Not starting when hot

Ford Ranger 2013 Dcab 2.2 T6 168023 miles
Ford ranger 2.2 2013 when hot not start replace crank sensor glow plug injectors replace harness check out same problem please help
Kobus from South Africa 3 years ago  
KO
12 reports 
power from South Africa 3 years ago
Same problem here did you get help
Yatesy from United Kingdom a year ago
I have the same issue. Starts when cold but not when hot. I have changed the crank sensor but no change. Can anyone help me out?
Merzdaman from other 9 months ago
I have this problem now... it's one kick start when cold... When hot its start but for 2secs... And its like miss fire
Comment

Stalling when clutching, Unstable idle

Ford Ranger 2013 3.2 Manual 4x4 Doublecab 70000 miles
When I brake (and press clutch) the rpms drop lower than they should, often resulting in stalling. I have replaced the injectors, and serviced the vehicle but still nothing. My plan is to replace the idle air control valve, but if anyone knows what the problem is please let me know.
Owen from South Africa a year ago  
OW
1 report 
sambuxton from United Kingdom 2 months ago
Did you manage to sort this? Im having the same problem.
Comment

Crank no start

Ford Ranger 2009 W.E. common rail engine 388477 miles
Changed the brass washers under the injectors with the glow plugs but now it cranks and would not start even used starting fluid to jump start but nothing still
1
Gringo from Trinidad and Tobago 18 days ago  
GR

Ford ranger t6 2.2 the injector pump not pumping

Ford Ranger 2014 PAT 2955000 miles
Injection pump not pumping fuel to the rail and the injectors
Esox from other 10 months ago  
ES
8 reports 

Bakkie wont start

Ford Ranger 2008 3.0tdci ranger 270000 miles
Hi bakkie wont start, when its hot or cold. Push by hand starts immediately. Had problems with the injectors got that fix bakkie was running fine for 3 weeks, and then it started again. Did the pressure velve on the side of the motor but still the same. Can it be the pressure vavle on the injector railing or not?
Nico from South Africa 10 months ago  
NI
2 reports 

Cranks but wont start

Ford Ranger 2020 2.2 TDCI diesel 11 miles
Piston was replaced. Crank censor not touched. Injectors was marked before taken out and placed back presicely where they came out. Enjin cranks but wont start. New filters, oil ext. 116000km on engin.
Jora from South Africa a year ago  
JO

I have replaced all piston on my 5 cylinder engine but diesel doesn't

Ford Ranger 2014 3.2 diesel 175000 miles
Why is diesel not reaching the injectors
Giant from South Africa 2 years ago  
GI
2 reports 

Fuel injection problem

Ford Ranger 2003 Hi trial 380000 miles
Hi All
The vehicle starts easily and on cold start will run for less than 5min before starting to develop a misfire or erratic idle every few seconds. On top of this problem it pumps out a lot of smoke (white /blueish colour). Once engine has run a while and one kills the engine and restarts it a few moments later then it doesn't smoke as bad but misfire or erratic idle still persists. Do I have a problem with the fuel injectors.
Doug bro from South Africa 2 years ago  
DO
8 reports 
Problems with a Ranger? Share them
Submit commentCancel
Submit replyCancel


Did you find the website helpful?

Thank you!