Accelerator problems

Top problems

Stuck in limp mode

Ford Ranger 2010 Manual ute 107000 miles
My 2010 PK Ranger is stuck in limp mode. When I start the car it needs a bit more than the quick turn of the key as it usually does. I have had this problem before but a new battery fixed it for a short time. Now I have the problem with it being in limp mode full time. I have reset and serviced the car fully, but it still won’t go over 2000revs.
Has anyone else had this problem? How did you solve it? Could it be the throttle sensor?
Gail from Australia 6 years ago  
GA
4 reports 
Michael from Ireland 6 years ago
Change the fuel filter that worked for me
Tyler from New Zealand 2 years ago
Did you resolve this. Im experiencing similar problems.
Michael from Ireland 2 years ago
No warning light came on my jeep it went into limp mode I changed the air filter now it works fine
Michael from Ireland 2 years ago
Sorry it was the fuel filter
Comment

Truck runs rough and stall out of the blue

Ford Ranger 1993 4.0 26800 miles
The motor runs rough and stalls out of the blue we have changed the fuel pump and injectors, plugs plug wires throttle position sensor checked the mass air flow and it is reading fine fuel pressure is good the check engine light will come on but it will not show a code had it put on computer and it shows every thing is working fine also changed the fuel pressure unit
cstrief from United States 8 years ago  
CS
18 reports 
Cqmanager from Canada 7 years ago
Try cleaning your injectors...alot of times they get fouled up and why it stalls... seafoam or equivalent has always worked for me
Comment

My ford ranger 3.2 t6 2013 cranks,starts and then stops

Ford Ranger 2013  200000 miles
My ford ranger cranks ,starts and then cut off again. I replaced my old engine with another engine,turbo charger,throttle board.It usually cranks and then starts again after a few minutes or hours. Sometimes it goes into safe mood but after a few minutes it removes itself again and sometimes it stops whilst trying to reverse it. What might be the problem?I've tried putting it on the machine bt the only issue being shown is to do with the rear speed sensors but my mechanic believes this has nothing to do with it cranking,starting and then failing to start again whilst showing a battery light and oil light switch light on the dashboard.
Dfdford from other 2 years ago  
DF
4 reports 
Chook from Australia a year ago
Check the big plug behind the passenger kick panel in the footwell. It is pulled tight and the pins can progressively pull out of the opposing plug, dropping power to dash and security immobilizer. Unplug and check all pins and sockets are the same length (push in from behind if not).
Charm from South Africa 4 months ago
Similar problem on ford ranger 2015 t6 2.2 engine cuts whilst driving then refuses to start
Comment

Scraping noise when reversing in 4 wheel drive

Ford Ranger 2014 2.2L auto 43000 miles
Went to reverse off my drive this morning and started hearing a scraping noise and noticed when I let of the accelerator the car stopped like it was under breaking. It feels like something is stopping it from creeping. I changed it into 2 wheel deive and the noise disappears and the car was able to creep again. I will drive in 2 wheel for now but any advise would be great as I’m not sure if I’m doing more damage just by driving it.
Shampain from United Kingdom 2 years ago  
SH
1 report 
Problems with a Ranger? Share them
Submit commentCancel
Submit replyCancel


Did you find the website helpful?

Thank you!