I have the same problem, symptoms are engine light check on ,no power on accelerator when pressed,brake indicator stays on, I believe its in limp mode ,will probably hook up a scanner to read fault codes then relearn accelerator pedal or reset ENGINE ECU.
@NooraProblem solved by:
1-Disconnect both battery terminals for more than 40 minutes. 2- connect terminals to battery. 3- Place car key into ignition but don’t start. Leave it until you see check engine light blinking for 8 times.
4- after it stops blinking turn on engine. 5- leave it to idle temperature
6- Drive vehicle.
1-Disconnect both battery terminals for more than 40 minutes. 2- connect terminals to battery. 3- Place car key into ignition but don’t start. Leave it until you see check engine light blinking for 8 times.
4- after it stops blinking turn on engine. 5- leave it to idle temperature
6- Drive vehicle.