CAS module. Car does not start also not cranking
2008 BMW 5 Series Sedan 250000 miles
Car start locking mode CAS MODULE LOCKED
8 reports
2
GR
No crank, replaced battery, replaced starter, transmission malfunction. Serviced transmission. Still won’t crank
Vote helpful2
BA
It is probably the wheel steering lock it is electrical and i had the same problem i fixed it by removing the cables from the battery for 30 min, i tried to restart with tester to delete all faults and it didnt work, only removing cables from battery to reset it completly fixed it
Vote helpful
F1
@BabaWhich cables exactly? I did remove the battery to go get it tested and charged up. Do I have to remove any other cables?
Vote helpfulRelated problems
No crank no start
2007 5 Series 4.4 v8Everything turns on but no crank no start how to I sync my module DME CAS FOR IT TO Start
K can line fault
2006 5 Series SedanThe dme, cas, instrument cluster, kombi, smfi, ohm and shd all show k can line fault codes, low voltage and it won’t start. 2006 530i
Cruise control not working
1997 5 Series sedanWhere is the cruise control module located?
No crank my car
2010 Cruze Kl1ja695jak742080Light lock isue,and no start enggine
Clicking sound from cas and footwell
2010 Cooper r56When i try to start the car it only clicks at footwell and at CAS in dash. Sometimes in the early morning it will go ahead and start. Plugged in computer and it says module 15 has a short in the CAS.…
I replaced used control module but it doesn't start
2013 Cruze SedanI have replaced Chevrolet steering control lock module but it doesn't start
1 reply
